ARMOR RESURFACER

ARMOR RESURFACER is a corrosion inhibiting, polymer modified shrinkage compensated, rapid setting, high strength mortar specially formulated for structural concrete repair in vertical and horizontal surfaces. It is suitable for areas such as:

Description

ARMOR RESURFACER is a corrosion inhibiting, polymer modified shrinkage compensated, rapid setting, high strength mortar specially formulated for structural concrete repair in vertical and horizontal surfaces. It is suitable for areas such as:

  • Interior and exterior
  • Levelling and repair of horizontal concrete surfaces
  • Structural repairs
  • Parking & bridge decks
  • Industrial floors, Gas Stations, Factory Floors etc

TYPICAL APPLICATIONS

ARMOR RESURFACER can be used for all structural concrete repairs such as:

  • Interior and exterior concrete surfaces
  • Repair of horizontal and vertical surfaces
  • Repair concrete sidewalks, spalled concrete
  • Industrial floors
  • Parking lots and bridge decks

ADVANTAGES AND BENEFITS

  • Aesthetically nice self-leveling and smooth finish
  • Good corrosion Inhibition property, therefore protect reinforcements
  • Minimal shrinkage and outstanding resistance to crack
  • Excellent bond strength
  • High abrasion resistance

SURFACE PREPARATION

Prepare concrete substrate in accordance with International Concrete Repair Institute (ICRI) Technical Guideline. Remove all unsound concrete and provide a profiled, porous surface. Substrate must be structurally sound, dust-free, and free of grease, oil, dirt, curing compounds, release agents, or any other surface or penetrated contaminants that will adversely affect bond. Pressure wash the surface with a commercial pressure washer (3000 psi, 4 GPM) (21MPa, 0.25 L/s) and allow to fully dry before application

PRIMING: in most instances priming will not be needed but for vertical surfaces and very porous concrete Apply one coat of ARMORPRIME 400 acrylic primer to allow for good bonding and adhesive purpose.

APPLICATION INSTRUCTION

MIXING: Pour 3.3 to 3.8litres of water into a clean plastic or metal bucket, pour 70% of ARMOR RESURFACER into the clean bucket of water, then mix with a power mixer at 400 RPM, after two minutes of mixing pour the rest of the material and mix until full homogeneity is achieved

APPLICATION AND INSTALLATION

Pour the material on the area to be resurfaced using a hand trowel or spray gun, because of the self-leveling property of ARMOR RESURFACER the material can easily be finished as desired, using either a trowel or a broom.  The level of thickness will also be determined by the application need, but should be achieved in one application; the mixed material can be applied at a thickness between 3mm and 20 mm. If the mix hardens, it should be disposed, please do not attempt to remix or add water to hardened mix.

DOWNLOAD DATA SHEET

Reviews

There are no reviews yet.

Be the first to review “ARMOR RESURFACER”

Your email address will not be published. Required fields are marked *

Product Enquiry

TOP