ARMORFLO 100 is a fiber reinforced polymer modified concrete resurfacer, which is trowellable and sprayable. ARMORFLO 100 is prepared by adding water and provides an aesthetically fresh appearance to old concrete surface, spalled concrete, salt damaged concrete and new concrete marred by rains.
- ARMORFLO 100 can be used for restoration of the following areas:
- Industrial floor resurfacing
- Car parks resurfacing
- Petroleum and Gas Station resurfacing
- Elevated slabs and every other concrete requiring resurfacing
ADVANTAGES AND BENEFITS
- Polymer modified and Enhanced Bond
- Micro Silica Enhanced/Low permeability
- Shrinkage Compensated/Low Rebound
- Highly Engineered/ Protect Embedded reinforcing Steel
The substrate must be fully cured and well prepared, it must be sound, clean, structurally stable, free from dirt, loose particles, efflorescence, chemicals and other contaminants, in order to ensure proper bonding.
Prepare concrete substrate in accordance with International Concrete Repair Institute (ICRI) Technical Guideline. Remove all unsound concrete and provide a profiled, porous surface. Substrate must be structurally sound, dust-free, and free of grease, oil, dirt, curing compounds, release agents, or any other surface or penetrated contaminants that will adversely affect bond. Pressure wash the surface with a commercial pressure washer (3000 psi, 4 GPM) (21MPa, 0.25 L/s) and allow to fully dry before application.
PRIMING: Apply one coat of ARMORPRIME 400 acrylic primer to allow for good bonding and adhesive purpose, for a very porous concrete surface ensure that two coat of primer is applied to ensure surface is well saturated with the primer before application.
MIXING : Pour 3.3 to 3.8 litres of water into a clean plastic or metal bucket , pour 70% of ARMORFLO 100 into the clean bucket of water, then mix with a power mixer at 400 RPM, after two minutes of mixing pour the rest of the material and mix until full homogeneity is achieved.