ARMORFLO 700

ARMORFLO 700 is a two component consisting of epoxy and polyamide resin based topcoat that possess high Physical and chemical resistance. It adheres perfectly to aluminum, galvanized metal and any other metal and also Concrete surfaces. It is a good solution in cases where high performance is of top importance. Also, it is resistant to Mineral oils, sea water and a lot of chemical substances.

Description

DESCRIPTION:

ARMORFLO 700 is a two component consisting of epoxy and polyamide resin based topcoat that possess high Physical and chemical resistance. It adheres perfectly to aluminum, galvanized metal and any other metal and also Concrete surfaces. It is a good solution in cases where high performance is of top importance. Also, it is resistant to Mineral oils, sea water and a lot of chemical substances.

ADVANTAGES:

  • High chemical and physical resistance
  • Excellent compressive strength
  • Excellent flexural and tensile strength
  • Seamless dust free and easy to clean.
  • Dense corrosion resistant surface

TYPICAL APPLICATIONS:

Armorflo 700 can be applied for floor finish coating on:

  • Industrial and factory floors
  • Water reservoirs
  • Flour silos
  • Petroleum and mineral oil tanks
  • Grain storage bins

APPLICATION INSTRUCTIONS:

Surface preparation;

Surface should be clean and dry and free of impurities and should be coated with primer.

SURFACES WITH PRIMING COAT/INTERMEDIATE COAT: Due attention must be paid to over coating times before applying the top Coat for the surfaces on which a primer and/or an intermediate coat was previously introduced. It is recommended that fully cured Surfaces should be roughened up before applying a top coat.

TOUCH-UP/REPAIR PROCEDURE: Surface to be repaired or touched up will be subjected to cleaning operation to remove Impurities, grease and salt with detergent and high-pressure water, and damaged surfaces will be cleaned by sandblasting Process to meet st-2 and st-3 grade. Cleaned surfaces must be coated with a proper primer. A surface which is dry, clean And/or coated with primer will be deemed proper for paint touch-up/repair.

LINELESS AND/OR NONFERROUS METALS: It is recommended to consult our Technical Support Services for aluminum, galvanized steel, stainless steel, concrete and plastic surfaces.

AMBIENT CONDITIONS: Surface temperature must be +10; +30 °C and relative humidity must be maximum 80% in order to achieve optimal results. Metal surface temperature must be at least 3°C above the dew point of air to avoid condensation on the surface. Good ventilation is essential for drying process in case the application is carried out in a confined space.

MIXTURE: Product must be blended using a mechanical mixer until it becomes a homogeneous mixture. Mixture viscosity must be adjusted with the recommended hardener and thinner, taking mixing ratio, mixture pot life and application equipment specified in the technical specifications section into consideration. Allow mixture to rest for 15 minutes after it is ready before starting the application.

APPLICATION OF THE PAINT: Painting process must be carried out by applying recommended wet paint film thickness in order to achieve the required dry film thickness, by paying due attention to the chosen application equipment after checking for the completion of surface conditioning operations.

APPLICATION METHODS: A temperature of 20°C is recommended for optimal results. Optimum settings for application must be specified taking application conditions, ambient temperature, film thicknesses and equipment information into account.

DOWNLOAD DATA SHEET

Product Enquiry

TOP