HYDROPLAST 260GR
HIGH RANGE SNF BASE WATER REDUCING
AND STRENGTH ENHANCING ADMIXTURE
Product Description
Hydroplast 260GR is a brownish, ready to use, high
range water reducing and strength enhancing
admixture. It is designed to produce high strength
concrete at low w/c. with an extended workability
- Reduced water to cement ratio for high strength
concrete - Low pumping pressure for pumped concrete
- Reduced thermal peaks for casting in hot climate
- Reduction in water intake for ultimate strength.
- Quality concrete at low cost.
Hydroplast 260GR is a high range SNF base water
reducing and strength enhancing admixture. It has a
good workability at low w/c. This admixture is
design for high strength concrete requirement,
durability improvement and reduction in
permeability.
Workability could be affected by the temperature
condition, type of cement and the nature of
aggregate. Therefore, it is strongly advised that
concrete materials should be carefully selected.
0.5kg, 20 pieces in a pack.
12 months stored in a cool dry place.
Dosage of Hydroplast 260GR is determine in trial
batch, to serve as guide, we recommend using 0.8
to 1.5% of the cementitious material, dosage also
depend on the design mix requirement. There is no
effect on concrete if higher dosage is been used.
Armorsil provides detailed method statements
on all its products for use in various applications.
Below is an information summary for guidance
Hydroplast 260GR is compatible with all grade of
cement (32.5, 42.5, 52.5) and most air entraining
agent, can be used with all grade of aggregate
meeting the ASTM standard.
Conforms to the requirements of BS EN 934-2
Table 9
Appearance: White
Like all material that contains Portland cement,
this material must be handled professionally as
it can cause irritation and burns. Therefore
contact with skin and eyes must be avoided.
All recommendations, statements and technical data herein are based on tests we believe to be reliable and correct, but
accuracy and completeness of said tests are not guaranteed and are not to be construed as a warranty either expressed or
implied. User shall rely on his or her own information and tests to determine suitability of the product for the intended use and user assumes all risk and liability resulting from his or her use of the product. Nothing contained in any supplied materials relieves the user of the obligation to read and follow the warnings and instruction for each product as set forth in the current Technical Data Sheet, product label and Safety Data Sheet prior to product use away. Armorsil Manufacturing supplies products that comply with the properties shown on the current datasheets. In the unlikely event that products supplied are proved not to comply with these properties, then we will replace the non-compliant product or refund the purchase price. Armorsil Manufacturing does not warrant or guarantee the installation of the products as it does not have control over the installation or end use of the products. Any suspected defects must be reported to Armorsil Manufacturing in writing within seven working days of being detected. Armorsil Manufacturing. Makes no warranty as to merchantability or fitness for a particular purpose and this warranty is in lieu of all other warranties express or implied. Neither seller nor Armorsil Manufacturing shall be liable to the buyer or any third person for any injury, loss or damages of any sort including remote or consequential damages, down time, or delay directly or indirectly resulting from use of or inability to use the product. . The information contained in the latest data sheet supersedes all previously published editions. Visits to site by Armorsil personnel do not constitute supervisory responsibility. Armorsil reserves the right to alter the information contained in this datasheet without prior notice
