ARMORGROUT 110
THREE COMPONENT EPOXY STRUCTURAL GROUT
Product Description
ARMORGROUT 110 is a three-component moisture tolerant structural epoxy grout
consisting of resin, hardener and special fillers the part that all have to be mixed together before use.
- Provides improved chemical and abrasion
resistance - High and early compressive strength gain
- grouting and bonding applications.
- Excellent adhesion and non-shrink.
- Adjustable flow for various conditions
- Working time can be controlled
ARMORGROUT 110 is recommended for use as a
structural adhesive and grout in concrete and
metal in areas such as:
- Anchoring steel bars
- heavy equipments and transporting rails
- chemical plants and testing equipments
- Under base plates
- Turbines, compressors, pumps
ARMORGROUT 110 is available in two different pack sizes consisting of (resin, hardener and filler). It comes in 8kg packs and 15kg packs.
With proper storage material can be stored and used within 12 months
STRUCTURAL GROUTING
Pour Component A and B in ratio in a clean container and mix using a low speed power drill for 30 seconds. Add component C in the mixture and mix for two minutes until homogeneity is achieved with a low speed power drill.
POURING
The mixture must be poured from one side steadily to eliminate entrapment of air.
Regulate the time of mixing and batching.
Ensure there is sufficient grout available before pouring.
Armorsil provides detailed method statements
on all its products for use in various applications.
Below is an information summary for guidance
The recommended dosage for Aquaseal 100 is
0.5 kg per bag of 50kg cement. Note that
optimum dosage to meet specific requirements
should always be determined by trial mixes using
admixture on site
Conforms to the requirements of BS EN 934-2
Table 9
Appearance: White
Like all material that contains Portland cement,
this material must be handled professionally as
it can cause irritation and burns. Therefore
contact with skin and eyes must be avoided.
All recommendations, statements and technical data herein are based on tests we believe to be reliable and correct, but
accuracy and completeness of said tests are not guaranteed and are not to be construed as a warranty either expressed or
implied. User shall rely on his or her own information and tests to determine suitability of the product for the intended use and user assumes all risk and liability resulting from his or her use of the product. Nothing contained in any supplied materials relieves the user of the obligation to read and follow the warnings and instruction for each product as set forth in the current Technical Data Sheet, product label and Safety Data Sheet prior to product use away. Armorsil Manufacturing supplies products that comply with the properties shown on the current datasheets. In the unlikely event that products supplied are proved not to comply with these properties, then we will replace the non-compliant product or refund the purchase price. Armorsil Manufacturing does not warrant or guarantee the installation of the products as it does not have control over the installation or end use of the products. Any suspected defects must be reported to Armorsil Manufacturing in writing within seven working days of being detected. Armorsil Manufacturing. Makes no warranty as to merchantability or fitness for a particular purpose and this warranty is in lieu of all other warranties express or implied. Neither seller nor Armorsil Manufacturing shall be liable to the buyer or any third person for any injury, loss or damages of any sort including remote or consequential damages, down time, or delay directly or indirectly resulting from use of or inability to use the product. . The information contained in the latest data sheet supersedes all previously published editions. Visits to site by Armorsil personnel do not constitute supervisory responsibility. Armorsil reserves the right to alter the information contained in this datasheet without prior notice
