ARMORLATEX TDS
NEXT GENERATION ACRYLIC POLYMER
LATEX FOR BONDING AND WATERPROOFING
Product Description
ARMORLATEX TDS is a next-generation Styrene acrylic
polymer latex admixture that is designed as an integral
adhesive for cement, bond coats, mortar and concrete
to improve bond strength, compressive strength,
chemical resistance and waterproofing properties.
- It protects structure against water
penetration and water damage for a long
time. - Increases resistance to weathering, such as
wetting and drying and freeze-thaw cycle. - Increases resistance to Chloride ion
- Reduced primary and secondary
efflorescence on structures - Because of its additional repellency property,
it is suitable for preventing wind rain - Reduce the probability of corrosion of steel
reinforced concrete - Protection against de-icing salts
- AQUASEAL 100 is particularly suited for
concrete, mortar and plaster requiring
waterproofing against chemical attack,
chloride ion and weathering etc - AQUASEAL 100 is suitable for all concrete
work requiring protection such as foundation,
pre-cast elements, concrete for structures
below the ground etc.
0.5kg, 20 pieces in a pack.
12 months stored in a cool dry place.
Standard dosage for AQUASEAL 100 is 0.5kg
per 50kg bag of cement. Varies with water
content
Armorsil provides detailed method statements
on all its products for use in various applications.
Below is an information summary for guidance
The recommended dosage for Aquaseal 100 is
0.5 kg per bag of 50kg cement. Note that
optimum dosage to meet specific requirements
should always be determined by trial mixes using
admixture on site
Conforms to the requirements of BS EN 934-2
Table 9
Appearance: White
Like all material that contains Portland cement,
this material must be handled professionally as
it can cause irritation and burns. Therefore
contact with skin and eyes must be avoided.
All recommendations, statements and technical data herein are based on tests we believe to be reliable and correct, but
accuracy and completeness of said tests are not guaranteed and are not to be construed as a warranty either expressed or
implied. User shall rely on his or her own information and tests to determine suitability of the product for the intended use and user assumes all risk and liability resulting from his or her use of the product. Nothing contained in any supplied materials relieves the user of the obligation to read and follow the warnings and instruction for each product as set forth in the current Technical Data Sheet, product label and Safety Data Sheet prior to product use away. Armorsil Manufacturing supplies products that comply with the properties shown on the current datasheets. In the unlikely event that products supplied are proved not to comply with these properties, then we will replace the non-compliant product or refund the purchase price. Armorsil Manufacturing does not warrant or guarantee the installation of the products as it does not have control over the installation or end use of the products. Any suspected defects must be reported to Armorsil Manufacturing in writing within seven working days of being detected. Armorsil Manufacturing. Makes no warranty as to merchantability or fitness for a particular purpose and this warranty is in lieu of all other warranties express or implied. Neither seller nor Armorsil Manufacturing shall be liable to the buyer or any third person for any injury, loss or damages of any sort including remote or consequential damages, down time, or delay directly or indirectly resulting from use of or inability to use the product. . The information contained in the latest data sheet supersedes all previously published editions. Visits to site by Armorsil personnel do not constitute supervisory responsibility. Armorsil reserves the right to alter the information contained in this datasheet without prior notice
