HYDROPLAST 210
MID-RANGE WATER REDUCING
SUPERPLASTICISER FOR RHEOPLASTIC CONCRETE
Product Description
Hydroplast 210 is ready to use, mid-range water-reducing admixture design to produce high slump concrete with workability retaining property. This product is chloride free and is SNF base
Hydroplast 210 considerably improves the properties of fresh and harden concrete.
- Micro-silica concrete
- Mass concrete pours
- Ready mixed concrete
- Long distance transport
- Pumped concrete
- Casting in hot climate
To obtain: - Reduced thermal peaks
- High workability for longer periods
- Low pumping pressure
- Delay setting with longer workability
- Improves durability
- Reduced permeability
Hydroplast 210 is available in 1000L, 210L, 25L, and 20L. this product is available on demand.
Hydroplast 210 is a ready to use liquid which is dispensed into the concrete together with the mixing water.
Appearance: Dark brown liquid
Specific Gravity: 1.175 ± 0.005 at 20° C
Density: 1.18g/Cm3 ± 0.01
PH: 7-9
Chloride content: Nil
Additional air entrainment: <2%
Water-reduction: 20–25 % of mixing water
Compatibility: Compatible with all types of Portland cement including Sulfate Resisting Cement (SRC)
Setting Time: 10-12 Hours
All materials, measurement and production are in
accordance with ASTM C-494 type G.
HYDROPLAST-200D should be added with the last third of mixing water or immediately after complete mixing water addition. Do not add directly to the dry mix or cement. For proper administration, an automatic dispenser shall be used.
- Wear protective gloves and eye protection during work
- Avoid contact with eyes and skin
- If skin contact occurs, wash skin thoroughly
- If in eyes, hold eyes open and flood with
- warm water and seek medical attention
- immediately
All recommendations, statements and technical data herein are based on tests we believe to be reliable and correct, but accuracy and completeness of said tests are not guaranteed and are not to be construed as a warranty either e x p r e s s e d or implied. User shall rely on his or her own information and tests to determine suitability of the product for the intended use and user assumes all risk and liability resulting from his or her use of the product. Nothing contained in any supplied materials relieves the user of the obligation to read and follow the warnings and instruction for each product as set forth in the current Technical Data Sheet, product label and Safety Data Sheet prior to product use away.
Armorsil Manufacturing supplies products that comply with the properties shown on the current datasheets. In the unlikely event that products supplied are proved not to comply with these properties, then we will replace the non-compliant product or refund the purchase price. Armorsil Manufacturing does not warrant or guarantee the installation of the products as it does not have control over the installation or end use of the products. Any suspected defects must be reported to Armorsil Manufacturing in writing within seven working days of being detected.
Armorsil Manufacturing. Makes no warranty as to merchantability or fitness for a particular purpose and this warranty is in lieu of all other warranties express or implied. Neither seller nor Armorsil Manufacturing shall be liable to the buyer or any third person for any injury, loss or damages of any sort including remote or consequential damages, down time, or delay directly or indirectly resulting from use of or inability to use the product. . The information contained in the latest data sheet supersedes all previously published editions. Visits to site by Armorsil personnel do not constitute supervisory responsibility. Armorsil reserves the right to alter the information contained in this datasheet without prior notice
